If I adjust my driver from the A1---(stock position driver loft at number printed on head and face open 1/2 degree, lie angle 58.50) to position A4--(loft now 1.5 degrees more--example 8.5 printed on driver head in the A4 position is now a 10 degree driver with a lie angle of 60 degrees) does this have any impact on the 1/2 degree open face?

The reason I ask is that I thought as you increase loft and lie --- you would naturally get more draw bias in the ball flight.

I was told that if I was to move from the stock A1 position to the A3 position ....same example as above....the A3 position make the 8.5 driver a 10 degree driver with a 60 degree lie angle but the face would change from 1/2 degree open to 1.5 degrees closed promoting draw it making it easier to square. This would mean that each adjustment of .75 degrees more upright effectively closes the face 1 degree.  

Can you confirm or shed some light on the above.  

The confusing thing to me is I thought as you increase loft and lie it would increase draw--but not so by your chart.

The reason I ask all this is because I just built a new driver using your head (a 910 D2 8.5 with a high end 48" shaft) ...I knew I needed about 10 degrees loft and 1-2 degrees close face from prior experience with a long driver.  I have it set in the a-3 position ..effectively 10 degrees and 1.5 closed if my assumptions are correct and I must say this thing is a bomb. I have picked up 25 yards over my prior long driver ----very similar specs.  

My question is ..... is there any way with 1.5 draw bias to get the lie angle to come down----I would love to have the club sit a bit flatter at address.

PLease let me know if my conclusions are correct in terms of the adjustments...............Thank you Norm NJ